Can the Ear Cushions Be Removed?

Yes. The ear cushions on the soundcore Space 2 are designed to be removable. You can take them off and put on a replacement set yourself at home — no tools are required. This is part of routine maintenance to keep your headphones fresh and comfortable.

The ear cushions are not left/right specific, so either cushion can be installed on either earcup.

This guide walks you through the full replacement process in five simple steps: removing the old ear cushion and installing the new one.

Notice Before You Start

• Turn off your headphones to avoid accidental button presses while you handle the earcups.

• Work on a clean, flat surface so parts stay in place and you can operate comfortably.

• Prepare: your soundcore Space 2 headphones and the replacement ear cushions (one for each earcup).

• Keep your hands clean and dry to keep the cushion material fresh.

Note: The ear cushions are not left/right specific — either fits either earcup, and the method is the same for both sides.

Part 1: Remove the Old Ear Cushion

1. Hold the earcup steady with your left hand.

2. Grip the edge of the ear cushion with your right hand.

3. Use your thumb to push the ear cushion inward from the outer side.

4. While pressing inward, pull the cushion firmly outward to release it from the earcup.

Tip: Work gently around the edge using your hands. The cushion is designed to release by hand, so there is no need for any tools.

Part 2: Install the New Ear Cushion

1. Align the positioning points — match each locating pin on the cushion with the corresponding hole on the earcup.

2. Press into place — insert the cushion and press evenly around the edges until it sits flush all around.

3. Done — repeat for the other side if needed.

Maintenance Suggestions

• Work with clean, dry hands to keep the cushion material fresh and comfortable against the skin.

• Align before pressing — taking a moment to line up the locating pins helps the cushion seat smoothly and evenly.

• Press evenly, not forcefully — the cushion is designed to snap in with consistent pressure around the edge.

• Check the fit — after installation, run your finger around the edge to confirm a clean, even finish with no raised sections.

What to Expect

• The new ear cushions should sit flush against the earcup with a clean, even finish.

• Both the left and right cushions are interchangeable — there is no need to match a specific cushion to a specific side.

• If a cushion feels like it could sit more evenly, simply remove it and reseat it, making sure all locating pins are correctly aligned with their holes.

If you encounter any other issues or your issue has not been resolved, please contact us for further assistance.