Add a Smoke Alarm E10 to your eufy APP
Step 1: Log in to your eufy Account
Step 3: Connecting the Smoke Alarm E10 to HomeBase Professional
Step 4: Pair the Smoke Alarm E10
Install and Test Smoke Alarm E10
Step 1: Choose a preferred installation method
Step 2: Test whether the Smoke Alarm E10 is working properly
A Smoke Alarm is a crucial safety device that detects smoke and provides an early warning of potential fires, helping to protect lives and property. Smoke Alarm E10 uses photoelectric technology (for smoldering fires) and integrates into eufy ExpertSecure system, sending alerts via alarms or mobile notifications.
Before Getting Started
Before installing the Smoke Alarm E10, you should register your eufy account and install HomeBase Professional according to the instructions.
Add a Smoke Alarm E10 to your eufy APP
Step 1: Log in to your eufy Account
-
Open the eufy App on your phone.
-
Log in to your eufy account. If you don’t have an account yet, create one by following the registration process.
Step 2: Add Smoke Alarm E10
-
On the app’s main screen, tap the “+” icon in the top-right corner.
-
Select “Alarm System” under the Security section, choose Smoke Alarm E10, and the designated home (where your HomeBase Professional is).
Step 3: Connecting the Smoke Alarm E10 to HomeBase Professional
-
Add the Smoke Alarm E10 under the designated home (where your HomeBase Professional is).
-
Select the HomeBase Professional that was previously provisioned.
Step 4: Pair the Smoke Alarm E10
-
Make sure the Smoke Alarm E10 is powered, then press the 'sync' button on the bottom (the one in the front is TEST/HUSH button) for 5 seconds. Expect the LED to flash green quickly.
-
After pairing is successful, you can set the device location.
Install and Test Smoke Alarm E10
Step 1: Choose a preferred installation method
-
After pairing is successful, click "Next" and you will see the installation notes.
Step 2: Test whether the Smoke Alarm E10 is working properly
-
After the installation is complete, you need to test whether the Smoke Alarm E10 can be triggered in time and receive a message on your phone.
-
The Smoke Alarm E10 is paired.
Troubleshooting Tips
-
Why doesn't the LED blink?
-
Please check if you have installed the battery with the right +/- direction.
-
If you confirm that the battery +/- is right, please buy a new battery and retry. The battery model is CR123A.
-
The LED Status
|
Scenerio |
Light |
|
Turn on after getting powered up |
red light flashes once/54 sec |
|
Connecting to HB/Account |
Flashing green, lasts 1min; Stops flashing in 5 seconds if the connection is successful |
|
The first connection is successful |
The green light stays on for 3 seconds, then distinguishes |
|
Factory Reset |
Hold SYNC for 10 seconds. The green light flashes for 3 seconds |
|
Alarming |
Red light flashes quickly |
|
Low Battery(<5% or working time estimated less than 1 month) |
Flashing red once/54sec |
|
The Alarm can't connect to Homebase |
Green lights flash 6 times |
|
The Alarm needs to be replaced |
Yellow light flashes 3 times/54 sec |
|
security mode |
Away, Home, Customize, OFF（disarm） |
|
Firmware upgrading (OTA won't carry on if under low battery mode) |
no light |
